Apply curve on servo screen

Newcal / opentx

Automatically exported from code.google.com/p/opentx

0 stars 0 forks source link

Apply curve on servo screen #71

Closed GoogleCodeExporter closed 8 years ago

GoogleCodeExporter commented 8 years ago

Which board (stock / gruvin9x / sky9x / Taranis) are you using?

I see the need for a curve that can be applied to the servo screen. This would 
make it easier to match two or more servos that are slightly different 
mechanically, rather than having to do it each curve on the mixers redundantly.

Please provide any additional information below.

Original issue reported on code.google.com by Pages.Fl...@gmail.com on 25 Jul 2013 at 8:44

GoogleCodeExporter commented 8 years ago

I see, you are quick ;)

Original comment by bson...@gmail.com on 25 Jul 2013 at 8:46

Changed state: Accepted
Added labels: Type-Enhancement
Removed labels: Type-Defect

GoogleCodeExporter commented 8 years ago

Issue 72 has been merged into this issue.

Original comment by bson...@gmail.com on 25 Jul 2013 at 9:31

GoogleCodeExporter commented 8 years ago

Done in LUA branch. Will be part of the next MAJOR release (because there is an 
EEPROM change)

Original comment by bson...@gmail.com on 26 Jul 2013 at 10:19

Changed state: Fixed