Can't set user pin after update to RTM.8

Nitrokey / nitrokey-start-firmware

A mirror of Gnuk's 1.0.x and 1.2.x branches.

56 stars 15 forks source link

Can't set user pin after update to RTM.8 #30

Closed gvintux closed 4 years ago

gvintux commented 4 years ago

Hello, I've updated my nitrokey start to RTM.8 I can change admin pin to 14-digit sequence, but can't do that for user pin. Here is the result, but gpg --card-edit says that

Error changing the PIN: Conditions of use not satisfied

Device: 
    Vendor: Nitrokey
   Product: Nitrokey Start
    Serial: FSIJ-1.2.15-67094445
  Revision: RTM.8
    Config: NITROKEY_START:dfu=no:debug=no:pinpad=no:certdo=yes:factory_reset=yes
       Sys: 3.0

gvintux commented 4 years ago

I've found my mistake, I should generate key firstly

szszszsz commented 4 years ago

Correct. I just checked and this is present in the documentation on the Start page already. One thing missing is the new 14-PIN limit. @alex-nitrokey @jans23 Could you add that there please?

Perhaps I should refer to this page from releases page too (edit: done).

alex-nitrokey commented 4 years ago

I did add the PIN requirements some days ago.