search

OEFW-community / RT-890-custom-firmware

Customised version of Radtel RT-890 Open Firmware https://github.com/DualTachyon/radtel-rt-890-oefw
Apache License 2.0
42 stars 30 forks source link

VFO mode channel name residue #121

Open jepotter224 opened 2 months ago

jepotter224 commented 2 months ago

Hello

With the 2.1.8 pcb 2.1 installed on a Radtel RT-890 V2.1 board radio built 3-2024, I find that in VFO dual display on VFO B a channel names displays no matter with frequency displays or is changed to. VFO A displays nothing. Should both VFO's be cleared when VFO mode is entered? I've not seen this before. If I do go to the Save Channel Menu item I do see the same name there as well. This name shown is the same as on one of my memory channels.

power on ht -> switch to VFO display (mine has dual display on) and see residue channel name on VFO B -> return to memory channel display and channels/frequencies appear correctly -> switch to VFO display -> goto VFO B -> change frequency and channel name remains the same -> switch to single channel display on VFO B, channel name remains shown

I hope this helps.

jepotter224 commented 2 months ago

image000001 (8)

image000000 (15)

NOTE: when in single VFO mode while receiving a signal, that in the overlayed RF Gain Control information does not show the channel name.

jepotter224 commented 2 months ago

Found that in SAVE CHANNEL that channel name display for the VFO. Once I remove it then it no longer displays.. So functionally, in VFO mode should a channel name so at any time?

reppad commented 1 month ago

Hi, As for ticket #122 , the firmware shown seems to be https://github.com/M7OCM/890-II. Do you have the same issue with the firmware hosted here?