StimPlan Model Plot: Default curves on

OPM / ResInsight

3D viewer and post processing of reservoir models

http://resinsight.org/

GNU General Public License v3.0

175 stars 92 forks source link

StimPlan Model Plot: Default curves on #8052

Closed hhgs closed 3 years ago

hhgs commented 3 years ago

Set default curves off = yellow in snapshot below:

kriben commented 3 years ago

@hhgs I interpret your drawing to enable these by default:

Formations
Facies
Porosity
Permeability
Stress
Stress Gradient
Young's Modulus
Possion's Ratio
K-Ic
Proppant Embedment

Are you sure about the four last ones? We also have some code to enable/disable "fluid loss"-related curves, but I think that can be removed?

hhgs commented 3 years ago

Please add to "default on" list:

Biot coefficient
k0

Fluid Loss coefficient to be toggled ON (table values will be used as shown) if "Detail fluid loss" model is turned OFF. But Rel.Perm, Poro-Elastic Constant and Thermal Exp. are normally not so import for simulations and should be OFF anyway.