search

OctoPrint / OctoPrint-Slic3r

Slic3r plugin for slicing within OctoPrint
GNU Affero General Public License v3.0
88 stars 30 forks source link

can't post a request, this is not an issue but a request #27

Closed cnlson closed 6 years ago

cnlson commented 6 years ago

is there any way to make this pull slic3r prusa edition?

https://github.com/prusa3d/Slic3r

eyal0 commented 6 years ago

Did you try the instructions?

https://github.com/OctoPrint/OctoPrint-Slic3r/wiki/How-to-install-Slic3r-on-RPi

cnlson commented 6 years ago

I'm looking to put a different slic3r, the prusa edition that has a different git than the standard slic3r

On Dec 26, 2017 8:36 AM, "Eyal - notifications@github.com" github.cnlson.f422ac2bc3.notifications#reply@reply.github.com wrote:

Did you try the instructions?

https://github.com/OctoPrint/OctoPrint-Slic3r/wiki/How-to- install-Slic3r-on-RPi

— You are receiving this because you authored the thread. Reply to this email directly, view it on GitHub https://github.com/OctoPrint/OctoPrint-Slic3r/issues/27#issuecomment-353975237, or mute the thread https://github.com/notifications/unsubscribe-auth/ABYA61vOKS8gf8BW1pf2DIu0RdqJSwCjks5tEQRwgaJpZM4RJ9YF .

eyal0 commented 6 years ago

I understand. In the instructions, it explains how to put the prusa edition. Did you try that?

eyal0 commented 6 years ago

It's been too long without an answer. I'm closing this. Re-open if you're still having trouble.