search

OllisGit / OctoPrint-FilamentManager

OctoPrint plugin to manage your filament inventory
GNU Affero General Public License v3.0
53 stars 24 forks source link

Nozzle heat too high #50

Closed BenDavidson90 closed 3 years ago

BenDavidson90 commented 3 years ago

Hi,

Since some days, I noticed thant my printer heat the nozzle 60° higher than what was set in Cura. I tested first by printing my files directly on the printer and all is OK so the problem is relative to octoprint. I came across this issue on the source repo that is the same as me. So, I disabled Filament Manager, tested the same files as before and the problem disappear, so I concluded that the problem is finaly comming from the Filament Manager plugin.

Is the problem known ?

OllisGit commented 3 years ago

Hi @BenDavidson90, not known!

Did you already checked your spool configuration in FilamentManager plugin?

In this example the selected spool has on offset of -20 and in gcode M104 S200. The result after print was started looks like this:

image

BenDavidson90 commented 3 years ago

Hi, I did few tests today and it turns out that it was my fault: I had set the temperature offset of the spool at 200... I use SpoolManager too and as in this one you can adjust the filament temperature I must have confused the two. Sorry !