Needed filament could not be calculated

[maceide]

Im having this message pop up all the time when starting prints..

[github-actions[bot]]

This issue has been automatically marked for closing, because it has not had activity in 30 days. It will be closed if no further activity occurs in 10 days.

[GaryStebbins]

I am having the same issue.

[nikoramiro]

Having the same issue here

[Poporacer]

Same issue here

[rhinomods]

I have been having this issue for a long time! starting to get very frustrating. I even reloaded my system that runs octoprint hoping everything being update would fix the issue. I have to tell it the same spool about 7-10 times then it finally starts working.

[github-actions[bot]]

This issue has been automatically marked for closing, because it has not had activity in 30 days. It will be closed if no further activity occurs in 10 days.

[Poporacer]

Still the same issue

[github-actions[bot]]

This issue has been automatically marked for closing, because it has not had activity in 30 days. It will be closed if no further activity occurs in 10 days.

[Poporacer]

This problem still exists

[github-actions[bot]]

This issue has been automatically marked for closing, because it has not had activity in 30 days. It will be closed if no further activity occurs in 10 days.

[github-actions[bot]]

This issue was closed, because it has been already marked for 10 days with no activity.

[mboehler]

I have this issue as well.