search

Open-Systems-Pharmacology / Forum

Discussion forum for the Open Systems Pharmacology Project
65 stars 19 forks source link

Parameter Identification #515

Closed Wenjing1018 closed 4 years ago

Wenjing1018 commented 4 years ago

Hello， In the Simulation Explorer mark the two simulations"Oral 500mg"and"oral 850mg",Select both intestinal permeability parameters and click the upper Add button,In the tab Configuration keep the default settings,In the Ribbon Bar Run & Analyze click Show Visual Feedback and then Run to start the optimization. but the Show Visual Feedback interface only show a simulated result, the selection part is grey, but the case is black, it can be selected, I want to know where my problem are?

f9c9c74c055398f4a8b583de632527e b92ecd8bd63c2d39c4ba30062a57aae
msevestre commented 4 years ago

How many outputs do you have that are mapped to observed data ? This is the first step of the PI definition. I believe that only outputs mapped to observed data will be shown here

Wenjing1018 commented 4 years ago

How many outputs do you have that are mapped to observed data ? This is the first step of the PI definition. I believe that only outputs mapped to observed data will be shown here are you talking about this part? Any questions? image

msevestre commented 4 years ago

Your screen shot only shows one output (first column) unless the path are different but this is not visible. Therefore only one output to select from the PI output selection.

I am not sure I understand your problem. What do you expect to happen?

Wenjing1018 commented 4 years ago

Your screen shot only shows one output (first column) unless the path are different but this is not visible. Therefore only one output to select from the PI output selection.

I am not sure I understand your problem. What do you expect to happen?

I'm sorry I don’t understand what’s your meaning. There are three different doses(three simulations) in my first column, and there are several data for each dose, but only one dose（one simulation） is shown in the show visual feedback, and the other two are not shown.

msevestre commented 4 years ago

@Wenjing1018

The combo box is only available WHILE the PI is running After the RUN, the information is discarded

Wenjing1018 commented 4 years ago

@msevestre PI is running started by clicking on RUN? How to run the PI? Thank you very much!

PavelBal commented 4 years ago

In this case, the PI is solved faster than you can click "Show visual feedback", so you only see the "VIsual Feedback" window after the run is finished :)

Wenjing1018 commented 4 years ago

@PavelBal In this case, how do I operate to show three simulations in the "VIsual Feedback"window?

StephanSchaller commented 4 years ago

You can't. You can only display one simulation output at a time.

Wenjing1018 commented 4 years ago

@StephanSchaller I tried to operate yesterday and understood the sentence——the PI is solved faster than you can click "Show visual feedback", so you only see the "VIsual Feedback" window after the run is finished.As you said,I can only display one simulation output at a time. Thank you very much!