I uploaded custom firmware to the OpenBCI cyton with Daisy board attached. I changed the board.begin in the setup to board.begindebug. I also attached pins 11 and 12 to a raspberry pi to read the debug output. Sometimes I can only read the first 10 packets that are sent from the Cyton. This is not affected by changing the baud rate. Is this a known problem? and if so, is there a workaround or other solution?
I uploaded custom firmware to the OpenBCI cyton with Daisy board attached. I changed the board.begin in the setup to board.begindebug. I also attached pins 11 and 12 to a raspberry pi to read the debug output. Sometimes I can only read the first 10 packets that are sent from the Cyton. This is not affected by changing the baud rate. Is this a known problem? and if so, is there a workaround or other solution?