TSTool currently clears the results automatically when the commands are edited. This was originally requested to make sure that users did not assume the results were current, when they were inconsistent with commands that had been edited. However, if troubleshooting a large workflow, it may be of interest to view results while troubleshooting the workflow.
Perhaps could just prominently indicate that the commands need to be rerun, such as a note next to the run buttons.
Subject of the issue
TSTool currently clears the results automatically when the commands are edited. This was originally requested to make sure that users did not assume the results were current, when they were inconsistent with commands that had been edited. However, if troubleshooting a large workflow, it may be of interest to view results while troubleshooting the workflow.
Perhaps could just prominently indicate that the commands need to be rerun, such as a note next to the run buttons.
Environment