search

OpenNeptune3D / OpenNept4une

Transform your Neptune 4 3D printer with OpenNept4une, a collection of scripts designed to replace the manufacturer's software, reverting to the original open-source projects for enhanced performance, reliability, and features.
GNU General Public License v3.0
322 stars 36 forks source link

[LCD] Mesh Count not reset after emergency stop #163

Closed Beagon closed 4 months ago

Beagon commented 5 months ago

Hi, I had something happen and did an emergency stop during the creation of a KAMP mesh and had the following happen the next time I tried to print:

IMG_20240401_192242097_HDR

Printer: Neptune 4 Plus

Steps to reproduce:

  1. Start a print with KAMP.
  2. Let KAMP do a couple probes.
  3. Emergency Stop the printer.
  4. FIRMWARE_RESTART
  5. Start print with KAMP again. Should start counting from the last probe it left off.

This seems to only be graphical.

leokeba commented 5 months ago

I have noticed this issue as well, but it seems more general than this case. Any probe command that was not part of the bed mesh procedure will have this effect, I often use the BED_LEVEL_SCREWS_TUNE macro before starting a print and it triggers the same issue.

phillipthelen commented 4 months ago

Should be fixed in dev