Transform your Neptune 4 3D printer with OpenNept4une, a collection of scripts designed to replace the manufacturer's software, reverting to the original open-source projects for enhanced performance, reliability, and features.
GNU General Public License v3.0
363
stars
40
forks
source link
Neptune 4 with X stepper 0.8a model and Y stepper 1.2a #210
After following the guide, I foolishly looked at the model number on the Y-Axis Stepper and determined it to be the 1.2a model. I also verified that in the printer.cfg they were set to 1.2.
However, after installing OpenNept4une and trying to run a bed mesh there was a loud whining noise from the x-stepper. I looked at that motor to verify that I hadn't chosen the wrong model and found that it was the 0.8A model.
Should I just modify the value in my printer.cfg and is it only the one location that I need to worry about? Namely
After following the guide, I foolishly looked at the model number on the Y-Axis Stepper and determined it to be the 1.2a model. I also verified that in the printer.cfg they were set to 1.2.
However, after installing OpenNept4une and trying to run a bed mesh there was a loud whining noise from the x-stepper. I looked at that motor to verify that I hadn't chosen the wrong model and found that it was the 0.8A model.
Should I just modify the value in my printer.cfg and is it only the one location that I need to worry about? Namely
[tmc2209 stepper_x] uart_pin: PB9 run_current: 1.2 interpolate: True stealthchop_threshold: 999999