UI v 1.2.12 - 4 Max shows incorrect bed size

[RuthlessTX]

Size: 225x225x265 is not correct for the MAX

[halfmanbear]

you have the correct printer.cfg installed? i believe these numbers are just pulled from moonraker via the klipper config

[phillipthelen]

What does fluid/mainsail show? Does the About page show your printers IP-Address?

[anarsoul]

4 Plus also shows incorrect size. Where in the config are these values?

[anarsoul]

position_max is 325 for [stepper_x] and [stepper_y] and it's 405 for [stepper_z]

[RuthlessTX]

Fluidd is correct.

Joel M. Gabel

"Any sufficiently advanced technology is indistinguishable from magic." - Arthur C. Clarke

On Tue, Apr 9, 2024 at 05:50 Phillip Thelen @.***> wrote:

What does fluid/mainsail show? Does the About page show your printers IP-Address?

— Reply to this email directly, view it on GitHub https://github.com/OpenNeptune3D/display_connector/issues/13#issuecomment-2044702078, or unsubscribe https://github.com/notifications/unsubscribe-auth/BHT66CQAY2KMQNQBN44LSKTY4PBYVAVCNFSM6AAAAABF2DFWSOVHI2DSMVQWIX3LMV43OSLTON2WKQ3PNVWWK3TUHMZDANBUG4YDEMBXHA . You are receiving this because you authored the thread.Message ID: @.***>

[phillipthelen]

the 225x225x265 size is the default value that is present on the display itself. So it seems like the connector doesn't set the value at all. Does it show your printer model on the about screen correctly?

[anarsoul]

Does it show your printer model on the about screen correctly?

Yes, it shows printer model correctly