Manual ground plane doesn't work

OpenPTrack / open_ptrack_v2

OPT v2 "Gnocchi" - adding object tracking and pose recognition

BSD 3-Clause "New" or "Revised" License

218 stars 64 forks source link

Manual ground plane doesn't work #141

Open VanDerSloth opened 3 years ago

VanDerSloth commented 3 years ago

Hello,

I'm trying to set up the system with two Intel Real Sense cameras. Right now I am stuck at getting a single one to work, though. I'm running a single_camera_tracking container from docker, and it launches fine, but the window for the manual ground plane estimation doesn't work. It shows up (with the title "pick 3 points"), but no gui elements like in the guide. I can set three (or more) points, but nothing happens when I try hovering over them holding the shift button. Am I doing something wrong or does the software not work right?

Thanks and kind regards

bsubbaraman commented 3 years ago

Hi VanDerSloth! I don't have a setup right now but I know this was working when I last used the system- when using manual ground plane the window will stay open, but should gray out after a few moments (as seen here). If it's not graying out, you might also try holding the 'control' button instead of shift (both shift & control are used to complete the manual selection). Hope this is of some help!

VanDerSloth commented 3 years ago

Hi, thanks for your reply and sorry for my late reaction, I wasn't at my workplace since that time and could only now try it out. Sadly, holding control doesn't change anything. The window also won't gray out or anything, I can only keep adding red dots to the still image.