search

OpenZWave / open-zwave

a C++ library to control Z-Wave Networks via a USB Z-Wave Controller.
http://www.openzwave.net/
GNU Lesser General Public License v3.0
1.05k stars 918 forks source link

Value Jumps, Energy Meters #1419

Open ado464 opened 6 years ago

ado464 commented 6 years ago

Hello, i have a ton of Aeotec Energy Meters Gen5, 3p3, 3p4, latest firmware and latest openzwave.

This is the configuration Group 1 : 10 Group 2: 1 Group 3: 4

Group 1 time: 60 Group 2 time: 600 Group 3 time: 120

And then i do a restart of openzwave and the values come up like this: Value1: Watt Value2: kWh Value3: Volt Value4: Ampere

It runs okay like this for a while, and then all of a sudden maybe a month later the values would swap like: Value1: Watt Value2: kWh & Voltage (switching back and forth) Value3: kvAh? (was not even set in config) Value4: Ampere

Has anyone else had this issue? Driving me insane. I need to "Refresh node info" on 1 meter like 10-15 times and then restart openzwave and maybe it would fall into place correctly

best regards, Ado

RicardP commented 6 years ago

I see this happen more or less often on some Nodes.

If selecting the erratic Node in OZW Control Panel and use function "Refresh Node Info" the fields seems restored, for a while...

Fishwaldo commented 6 years ago

need to get some logs from around the time the values switch...

ado464 commented 6 years ago

zwave-info.txt

Hey Fishwaldo! Hope this little log can help out, there is some report of kvAh and some kWh that are actually voltage values of 228 etc

Sorry for late reply, it's been hectic

best regards, Ado

ado464 commented 6 years ago

Hey guys, any info or would you need another dump?

best regards, Ado