search

Owne / ardupilot-mega

Automatically exported from code.google.com/p/ardupilot-mega
0 stars 0 forks source link

In APM 2 there is no way to set up the power sensor #335

Closed GoogleCodeExporter closed 8 years ago

GoogleCodeExporter commented 8 years ago 
What steps will reproduce the problem?
1.In 'setup' there is no 'current' attribute to set.
2.In Planner PID Config - MVALink there is only a 'BATT_CAPACITY" attribute.  
No Power Sensor values.
3.'test' > current Reports 'Not Enabled'

What is the expected output? What do you see instead?
Expected to see:  setup > current on,  setup > current 2300  as in Beta 2.012

What version of the product are you using? On what operating system?
APM 2
Windows 7

Please provide any additional information below.

Original issue reported on code.google.com by stafford...@att.net on 2 May 2011 at 4:51

GoogleCodeExporter commented 8 years ago 
Please see the revised wiki page.

http://code.google.com/p/ardupilot-mega/wiki/Voltage

Original comment by dewei...@gmail.com on 4 May 2011 at 2:56