FAQ Hardware Connection needs the following changes:
Change:
Included with your Nextion screen you find the connection cable for the screen. It's a 4-wire cable with a Red (5-8v), Blue (TX), Yellow (RX) and Black (GND)lead.
To:
Included with your Nextion screen you will find the connection cable for the screen. It's a 4-wire cable with a Red (5-8v), Blue (TX), Yellow (RX), and Black (GND) lead. Note: If the positive and negative pins on the USB power adapter extend past the back side of the circuit board, trim them almost flush with the circuit board.
Change:
Connect the TX (Yellow) lead to the RX on your device (Raspberry, USBtoTTL adapter or Modem board)
Connect the RX (Blue) lead to the TX on your device
To:
Connect the RX (Yellow) lead to the TX on your device (Raspberry, USBtoTTL adapter or Modem board)
Connect the TX (Blue) lead to the RX on your device (Raspberry, USBtoTTL adapter or Modem board)
FAQ Hardware Connection needs the following changes: Change: Included with your Nextion screen you find the connection cable for the screen. It's a 4-wire cable with a Red (5-8v), Blue (TX), Yellow (RX) and Black (GND)lead.
To: Included with your Nextion screen you will find the connection cable for the screen. It's a 4-wire cable with a Red (5-8v), Blue (TX), Yellow (RX), and Black (GND) lead. Note: If the positive and negative pins on the USB power adapter extend past the back side of the circuit board, trim them almost flush with the circuit board.
Change: Connect the TX (Yellow) lead to the RX on your device (Raspberry, USBtoTTL adapter or Modem board) Connect the RX (Blue) lead to the TX on your device
To: Connect the RX (Yellow) lead to the TX on your device (Raspberry, USBtoTTL adapter or Modem board) Connect the TX (Blue) lead to the RX on your device (Raspberry, USBtoTTL adapter or Modem board)