search

PaulJenkin / PS4RaspberryPi

PiZero to host a server and emulate USB loading when necessary
230 stars 45 forks source link

SOLVED: PZW Failed trigger the Exploid #37

Closed PittStone closed 2 years ago

PittStone commented 2 years ago

I have a fresh install of PiZW-v11-reBuild2 and after setup DNS and go to the Page for Goldhen it shows the Notification for USB Emulation starting. Than i waiting over and over Minutes and nothing happens. If i klick O.k. a Message shows "Failed Trigger the Exploid..."

If i change to load "goldhen_2.0b_900.bin" it fails, too. Only i can activate "goldhen_2.0b2_900.bin".

PaulJenkin commented 2 years ago

Have you tired Rebuild 1 is it working for you? If that is also not working i would do the below

  1. Check if micro USB is plugged in the USB slot of PI
  2. Change the cable which you are using as there are some cable which are only for power and not for data
PittStone commented 2 years ago

If i change to load "goldhen_2.0b_900.bin" it fails, too. Only i can activate "goldhen_2.0b2_900.bin".

PittStone commented 2 years ago

Loading other goldhen works if i close the Userbook and open it again. But the same Error happens with Rebuild 1! Its failed to trigger the Exploid. I have also changed to a external Power adaptor without plug in usb to PS4.

PittStone commented 2 years ago

After i press o.k. A System Message appears "The free system memory is insufficient". My Free System Memory is 81GB.

PittStone commented 2 years ago

After other two Tests, another USB Cable was the right for Data-transfer pi to ps4. Thats why nothing Notification happens.