The screen might be broken, cannot continue further

[lexuv2]

I brought new papirus and it was working fine for a week, then i tried to set up https://github.com/f4exb/papiclock ,and after papirus-test I got

Assuming this is a PaPiRus Zero board

---- Detect temperature sensor and RTC (RTC for HAT only) ---- NXP LM75BD detected at: 0x48

---- Screen Information ---- Temperature from sensor: 32 degrees Celsius Panel info: EPD 2.0 200 x 96 version=4 COG=2 FILM=231

The screen might be broken, cannot continue further

after sudo i2cdetect -y 1 I got 0 1 2 3 4 5 6 7 8 9 a b c d e f 00: -- -- -- -- -- -- -- -- -- -- -- -- -- 10: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 20: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 30: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 40: -- -- -- -- -- -- -- -- 48 -- -- -- -- -- -- -- 50: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 60: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 70: -- -- -- -- -- -- -- --

I'm sure that screen is not broken using raspberry pi zero w and I tried reinstalling raspbian

[tvoverbeek]

What do you get as output for cat /dev/epd/error after running the failed papirus-test? Looking at https://github.com/f4exb/papiclock this is running on the larger 2.7" display. Are you trying it on a 200x96 (Pi zero size) display? Anyway it detects the clockchip on the PaPiRus Zero board.

[lexuv2]

I got Panel broken and I have 2 inch display 200x96

[tvoverbeek]

You can also get this message if the flex cable from the display to the FPC connector on the board is not properly connected.

[lexuv2]

I think i got the issue can i fix that?

[tvoverbeek]

That does not look good. Any idea how it got damaged?

[lexuv2]

No it was glued to the base

[tvoverbeek]

Probably time to contact the supplier. Did you get it from Pi Supply?

[lexuv2]

No from https://botland.com.pl/ (polish electronic shop)

[shawaj]

Did you glue it to the base? Because we do not glue the screens to anything.

[lexuv2]

by the double sided tape what was included in kit

[shawaj]

So how did the display break like that?

[lexuv2]

I think I was a delivery problem

[shawaj]

If it was damaged like that on delivery, there's no way it would have worked in the first place.

Anyway can you send a picture of the entire display too?

[lexuv2]

I think it was damaged a little, and I made it bigger

[shawaj]

You can purchase a new screen here - https://www.pi-supply.com/product/epaper-displays/