Closed johnhorner closed 7 years ago
I put some instructions in the wiki for this. I didn't make a video, but hopefully this is helpful. https://github.com/PiSupply/PaPiRus/wiki/Physical%20Assembly
Thanks! But this is the part I'm not getting:
The screen connects via a ribbon cable on the edge of the circuit board and bends around so the screen rests against the flat side.
How does it connect?
I've got the answer now. The brown part of the connector on the HAT can be opened, gently lever it up, put the ribbon in then put it down again to clamp on the ribbon.
bingo!
Thanks for linking this.
Our new team member Francesco is working on full picture based setup guides for all of our products, old and new, to make this process much easier for everyone
On 10 Dec 2016 6:03 am, "vogonsaudi" notifications@github.com wrote:
bingo!
— You are receiving this because you are subscribed to this thread. Reply to this email directly, view it on GitHub https://github.com/PiSupply/PaPiRus/issues/63#issuecomment-266181924, or mute the thread https://github.com/notifications/unsubscribe-auth/ADNCum0_a7kaCRYmTRhfKaGora0t3400ks5rGkCsgaJpZM4LJjOH .
I'll close the issue as we will address the documentation in due course with a proper assembly guide. I will link the guide to the README.md as soon as it is made available.
When they are available, they will be at https://pisupp.ly/papirus and https://pisupp.ly/papiruszero
Nothing there yet - but will be when ready
This is obviously too simple for most people, but I'm stuck. How do I connect the ribbon from the screen to the HAT? There's an obvious slot for it to go into, but it's just loose and comes out again. Is there some kind of clip involved? I'm concerned I'll break it.
Nowhere on the internet can I find instructions or a video on this first, most basic step. Anyone?