"Ramp" LFO shape repeats when step size is not set to 1, should only run once

[frenno]

Device(please complete the following information):

• Device: Bridge 6
• Firmware version: v1.2.1
• Hardware version: 1.0.1

Describe the bug The "Ramp" shape in the Switch LFO settings should rise once and then stop. However it keeps repeating (and therefore is the same as the "Sawtooth" shape)

To Reproduce

1. Use a blank template, add a CC message to the Toggle On stack of FS1 in bank 0 (eg Ch1, Controller 0, value 0)
2. Enable the Switch LFO on FS1 and choose the "Ramp" shape. Other settings are not important.
3. Save to device and press FS1
4. Using a MIDI monitor, observe that the LFO runs repeatedly instead of once

Expected behavior When set to "Ramp" the LFO should only run once.

Additional context Happens whether Trigger is set to Toggle or Hold

[simonaglover95]

Hey @frenno I can't replicate this bug. When I set the LFO on FS1 via the editor or onboard, I get a single ramp and it stops. If you could email a video that'd be good. But first, if you can, try to factory reset your device if you didn't after the last firmware update.

[frenno]

I already did a factory reset after running into this issue (before replicating with a new blank template config for this bug report).

Have made a quick video, sending through now.

I forgot to mention before but I also tried setting it on the device (not web editor), still the same result.

[frenno]

Ok as per your email, I've done some more testing - I had previously tried multiple other step sizes but not step size=1. And it turns out it only works for me when step size is 1 - I have updated the title to reflect this

[samspencer5991]

Fixed in v1.2.2