search

Play-Zone / MCU90615

Arduino-Sketch for the MCU90615V2-Breakout
MIT License
1 stars 1 forks source link

Confusing outputs #1

Closed BrucePD closed 5 years ago

BrucePD commented 5 years ago

Hello. I used example for my MCU90615 modul, but the outputs are confusing me, so i would like to know if you could help me on it.

https://prnt.sc/mxrvn8

Play-Zone commented 5 years ago

Looking at your output, it's from a completely different sketch than the one provided.

BrucePD commented 5 years ago

Hello,sorry for the mistake but even using the correct code https://github.com/Play-Zone/MCU90615/blob/master/example.ino i still have an issue. The serial monitor don't show any output. not sure if my connection is wrong or something. Could you help me?

The connections http://prntscr.com/mxt0ov wires colors: Red -> VCC White -> GND Green -> TX Blue -> RX

Thanks for the fast answer.

Em qui, 14 de mar de 2019 às 09:36, PLAY-ZONE GmbH notifications@github.com escreveu:

Closed #1 https://github.com/Play-Zone/MCU90615/issues/1.

— You are receiving this because you authored the thread. Reply to this email directly, view it on GitHub https://github.com/Play-Zone/MCU90615/issues/1#event-2203238942, or mute the thread https://github.com/notifications/unsubscribe-auth/AuTkK-LZVXUcqT2kE-bpKqBDjIdaPcMBks5vWkIxgaJpZM4b0ApA .

--

Play-Zone commented 5 years ago

You seem to have an older version of the breakout, this sketch is tested for the GY-MCU90615V2 only: https://www.play-zone.ch/en/gy-ir-therometer-breakout-mit-dem-mlx90614.html

We cannot test if the sketch works with your board, or if it's just a problem with your setup.

Only these connections are required: VCC VCC GND GND IO 10 TX IO 11 RX

BrucePD commented 5 years ago

I understand, thanks for the help.

Em qui, 14 de mar de 2019 às 10:46, PLAY-ZONE GmbH notifications@github.com escreveu:

You seem to have an older version of the breakout, this sketch is tested for the GY-MCU90615V2 only: https://www.play-zone.ch/en/gy-ir-therometer-breakout-mit-dem-mlx90614.html

We cannot test if the sketch works with your board, or if it's just a problem with your setup.

Only these connections are required: VCC VCC GND GND IO 10 TX IO 11 RX

— You are receiving this because you authored the thread. Reply to this email directly, view it on GitHub https://github.com/Play-Zone/MCU90615/issues/1#issuecomment-472861233, or mute the thread https://github.com/notifications/unsubscribe-auth/AuTkK7PeL54oQEUQUzr0Udq5rZAxX4xsks5vWlLHgaJpZM4b0ApA .

--