Closed smcbride-ca closed 2 years ago
No change while using https://github.com/rommulaner/Anycubic_Vyper_MB_CE_6.1d
I've just uploaded my reworked 6.1d. The 1.5mm issue should now be solved with that. I did't have time to print a cube today. Z=0 is now after leveling and Z-Offset fine tuning the bed surface.
Fixed in the new 6.1d revision. Closing the issue.
Did you test the latest
extui
code or prerelease?Yes, and the problem still exists.
Bug Description
The height of objects that have been printed is taller than shown in the slicer. This only began after switching to CE firmware. Example: Calibration cube, 20 20 20. Stock firmware produces a cube ~20 ~20 20. CE Firmware produces a cube ~20 ~20 21.5mm. This occurs on all models tested
All stock hardware Calibration cube.gcode.zip
Bug Timeline
After switching from stock to CE
Expected behavior
The height of the object should match the slicer.
Actual behavior
The height of the object is taller than in the slicer
Steps to Reproduce
Version of CR6Community Firmware
6.1c
Printer model
Vyper
Motherboard
Stock
Display
Stock
Bed Leveling
UBL Bilinear mesh
Your Slicer
Super Slicer
Host Software
OctoPrint