I preheat a printer to 240/104 and start autoleveling with same temps in the autoleveling settings.
Looks like I found a bug. Printer doesn't hold bed temperature when makes autoleveling.
If I set the bed temp to 104 (7x7 autoleveling) then at the middle of process it will be around 97 and at the end of process - around 94*.
The nozzle temperature 230 -> 226.
Did you test the latest
extui
code or prerelease?Yes, and the problem still exists.
Bug Description
Hello.
6.1E LA Direct 7x7.
I preheat a printer to 240/104 and start autoleveling with same temps in the autoleveling settings.
Looks like I found a bug. Printer doesn't hold bed temperature when makes autoleveling. If I set the bed temp to 104 (7x7 autoleveling) then at the middle of process it will be around 97 and at the end of process - around 94*. The nozzle temperature 230 -> 226.
Bug Timeline
No response
Expected behavior
No response
Actual behavior
No response
Steps to Reproduce
No response
Version of CR6Community Firmware
6.1e Vyper
Printer model
Other (I will explain below)
Motherboard
Other (I will explain below)
Display
Other (I will explain below)
Mods
No response
Add-ons
No response
Bed Leveling
None
Your Slicer
None
Host Software
None