search

Portisch / RF-Bridge-EFM8BB1

Alternative Firmware for the Sonoff RF Bridge EFM8BB1 chip
293 stars 124 forks source link

RfRAW 177 or RfRAW AAB155 cmd using fixed #145

Open supertobi265 opened 4 years ago

supertobi265 commented 4 years ago

Hello everyone. I am new here. I am using a RF- Bridge with portisch firmware for decoding a Dooya 1602. That works very well, but my problem is, that the RfRAW mode is not switched on for everytime. Sometimes it works 10 minutes or 10 hours and when I switched off the power from the bridge is the RfRAW mode also switched off. I hope evereryone have good idea.

Greatings from Magdeburg Germany

marceltech commented 4 years ago

hello I stuck on the same, did you get it solved?

aymeric106 commented 4 years ago

Hi, I think it is expected on reboot

RfRaw This command only works when the firmware has been updated with Portisch firmware. Refer to the Portisch wiki for details.Learning and Decoding RF Codes with Portisch Firmware0 = Set iTead default firmware support and messages (default on restart)

You can add a rule to trigger on boot ( trigger -> System#Boot) and perhaps like this trigger RfRaw#Data=OFF

Aymeric

aymeric106 commented 4 years ago

perhaps this also

https://github.com/arendst/Tasmota/issues/7064

vampywiz17 commented 4 years ago

@marceltech @supertobi265

Old .hex solve this?