When defining and/or activating a different coordinate system, all the
coordinate values should be relative to that system.
To replicate:
1) Define a new coordinate system and set active.
2) Draw a cylinder, point or any other entity using that system.
3) The position of the center shown in the properties tab is always relative to
the initial system at 0 0 0.
Original issue reported on code.google.com by thehellw...@yahoo.com on 14 Jun 2010 at 8:53
Original issue reported on code.google.com by
thehellw...@yahoo.com
on 14 Jun 2010 at 8:53