Cost information has to be entered in the mapeditor by the user, but here is no warning/error/indication of which "Type" of costs has/can be entered and what the "Unit" (EUR/EURO/m3/....) must be for the applicable asset for which the data is being entered. This also various for the different assets. MILP only uses specific costs, and currently the user can enter costs into mapeditor without knowing that the cost value might not even be used.
[ ] Warning message - Investment cost: if no Power capability is specified in the mapeditor, then the max demand of the demand profile is used to size the heating demand and calculate the specific heating demand investment cost
[x] unique names
[x] cost information, number and unit check
[x] name of the supply and return network
[x] number of ports on joints
[x] all ports connected
[x] maxcharge/discharge rates heat storages
[x] tank storage: capacity or volume defined
[x] heat exchanger: capacity or heat transfer coefficient
[x] generic conversion: power
[ ] check connection of assets in/outport to supply or return of network. (e.g. based on set carrier temperature). Demandlike: Carriertemperature inport>carriertemperature outport. Producer like: Carrier temperature outport> carriertemperature inport. Also do this for the primary and secondary side of networks.
Cost information has to be entered in the mapeditor by the user, but here is no warning/error/indication of which "Type" of costs has/can be entered and what the "Unit" (EUR/EURO/m3/....) must be for the applicable asset for which the data is being entered. This also various for the different assets. MILP only uses specific costs, and currently the user can enter costs into mapeditor without knowing that the cost value might not even be used.