search

Prutsium / 3D-Druckerplausch-Klipper

Repo for config file(s) for Prusa MK3(S)(+) with Klipper
36 stars 21 forks source link

Stuck after flashing #9

Open kaisarantonn opened 2 years ago

kaisarantonn commented 2 years ago

When flashing atmega with your guide, the both of fans spins and this screen appear image But the star indicator is moving left and right.

But

After flashing atmega etc. using kiauh via USB. The star stopped and nothing happend. Screen is stuck and fans keep spinning

Help me please

acdarby commented 2 years ago

I had this issues when re-flashing but I just turned the printer off and on (I guess not the best way) - then restarted the flash from the command line. I don't use Kiauh for updates only the initial install. see the https://www.klipper3d.org/Installation.html guide and the "Building and flashing the micro-controller" for the Instructions that worked for me. Hope that helps a bit!

kumar01254 commented 6 months ago

Hi, I am also facing the same issue, any suggestions or updates regarding this issue?