search

QIDITECH / QIDISlicer

QIDISlicer gets your 3D printing easier and faster.
https://qidi3d.com/
GNU Affero General Public License v3.0
40 stars 10 forks source link

QIDI Slicer 1.1.1 Max Volumetric Speed calibration #41

Closed Vance1122 closed 4 months ago

Vance1122 commented 4 months ago

This test really needs to be run in vase mode. Having it stop on one layer and then start the next layer in a random place is broken and leaves a lot of questions about where the MVS maxes out.

Vance1122 commented 4 months ago

OH. And if you try to change the print settings to enable vase mode, it gives an error that vase mode only works with single material printing even though we are using one filament to do our calibrations.

QIDITECH commented 4 months ago

I'm sorry, I don't understand. Our calibration procedure did not activate vase mode.

Vance1122 commented 4 months ago

But it should. This calibration is supposed to be in vase mode.

On Sun, Feb 18, 2024, 17:55 QIDI TECH @.***> wrote:

I'm sorry, I don't understand. Our calibration procedure did not activate vase mode.

— Reply to this email directly, view it on GitHub https://github.com/QIDITECH/QIDISlicer/issues/41#issuecomment-1951564623, or unsubscribe https://github.com/notifications/unsubscribe-auth/ADAWOCIJ32YBO3HDDTSAOG3YUKWKNAVCNFSM6AAAAABDNT23DWVHI2DSMVQWIX3LMV43OSLTON2WKQ3PNVWWK3TUHMYTSNJRGU3DINRSGM . You are receiving this because you authored the thread.Message ID: @.***>

QIDITECH commented 4 months ago

As you know, vase mode may be more suitable for printing, but it is not easy to adjust the speed.