Open 53Aries opened 1 month ago
Here you go A-8(RP) V1.0_001 PIN.pdf X-7 V1.1_001 PIN.pdf
My unit has A-7 toolhead board. Do you have a pinout for that?
Here you go A-8(RP) V1.0_001 PIN.pdf X-7 V1.1_001 PIN.pdf
Can you tell me if on the Q1 the A-7 toolhead board is using CAN or USB?
It's using serial, and here is the make menuconfig for the toolhead, it might require using STM32-Link to flash
It's using serial, and here is the make menuconfig for the toolhead, it might require using STM32-Link to flash
I believe this is for the mainboard. The toolhead is an rp2040.
Yes, I confused it with another model
Yes, I confused it with another model
No worries. I ask because I'm unable to find the rp2040 toolhead board listed in the linux environment. It doesn't show as a usb or serial device. Wondering how the x7 mainboard host is configured to connect with the A7 toolhead. In the qidi config the toolhead mcu is listed as ttyS2 so i assume serial.
Hi, is there also a pinout for the X-7 v1.0, as it seems to be different from the 1.1 you shared above.
Additional question, is there a possibility to bypass the SOC and connect e.g. a Raspberry to the STM32F402 MCU? Thanks!!
Additional question, is there a possibility to bypass the SOC and connect e.g. a Raspberry to the STM32F402 MCU? Thanks!!
Not sure 😢
Any chance we can have the pinout diagram and/or schematic for both the main board and toolhead board? Thanks