need help unable to use with rpi2

[deep4U]

when I run example code I get all this neither the cmos led turns on nor did I press my finger which was falsely detected the same output comes always with same observation but my sensor works properly with arduino GT511C1R is the one I am using and my board is raspberry pi 2 any Ideas what is wrong?

python ./raspberry_pi_GPIO_test.py Command: Open 55 aa 01 00 01 00 00 00 01 00 02 01 U������ U\xaa\x01\x00\x01\x00\x00\x00\x01\x00\x02\x01 readed: Command: CmosLed 55 aa 01 00 01 00 00 00 12 00 13 01 U������ U\xaa\x01\x00\x01\x00\x00\x00\x12\x00\x13\x01 readed: Put your finger in the scan Command: IsPressFinger 55 aa 01 00 01 00 00 00 26 00 27 01 U���&'� U\xaa\x01\x00\x01\x00\x00\x00&\x00'\x01 readed: Your finger is in the scan Command: CmosLed 55 aa 01 00 00 00 00 00 12 00 12 01 U����� U\xaa\x01\x00\x00\x00\x00\x00\x12\x00\x12\x01 readed: Command: Close 55 aa 01 00 00 00 00 00 02 00 02 01 U����� U\xaa\x01\x00\x00\x00\x00\x00\x02\x00\x02\x01 readed:

[himanshu-hearthacker]

facing same problem, did you get any solution yet?

[felipefuller]

I have the same problem! any solution?

[felipefuller]

Found a temporary solution! after searching the whole internet, i installed de 2015-05-05 wheezy image from: https://downloads.raspberrypi.org/raspbian/images/ Then i used this code to try the sensor http://makesensors.botbook.com/code.html and worked :) Now im trying to use this library. I've had a some errors, but should work. I hope this can help you!

[deep4U]

Hey guys sorry have been busy lately still facing same issues tried lots of things gonna try @felipefuller 's solution this weekend and get back ASAP

[deep4U]

I read the code from http://makesensors.botbook.com/code.html for those having dificulties in finding it is in fingerprint_scanner as a python script also I would remove these lines from the script's main before running print("Remove all identities from scanner") and removeAll() as I want to just check the led is getting on or not. :-) Will install the said version of wheezy on my pi and run this script to let you know thanks

[felipefuller]

after trying that solution, i noticed the response of the FPS was very slow. It worked, but was very slow. I also removed the "removeAll()" and enrolled without problems. After trying any possible solution to get this library working, i gave a shot to the node.js library and worked surprisingly good!

[Mehluko]

@ felipefuller how did you get the code from node.js script working I'm trying to use it I can get it working.w@ steps did you follow?

[himanshu-hearthacker]

replace FPS.py in your code with file named FPS2.py. https://github.com/Jucker/SIPIntercom-with-FPS .This is guy modified the file to work with code. if you face any problem try to change the baud rate 2-3 time.