Bug when switching between miller and printer mode

RF1000 / Repetier-Firmware

Firmware for the Renkforce RF1000 3D Printer

21 stars 16 forks source link

Bug when switching between miller and printer mode #17

Open Cirrus01 opened 8 years ago

Cirrus01 commented 8 years ago

When switching the mode in the menu the z-endstops are not recognized. Reaction is normal after reset.

RF1000 commented 8 years ago

Which version of the firmware did you use?

Cirrus01 commented 8 years ago

Hi RF1000,

sorry but I was busy with other things. I noticed this with V 0.91.59. But for me it's no issue any longer as I separated my endstopps and optimised the FW.

You may close this issue if you want.