v 91.53 can not home or move z in printer mode directly after homing z in milling mode

RF1000 / Repetier-Firmware

Firmware for the Renkforce RF1000 3D Printer

21 stars 16 forks source link

v 91.53 can not home or move z in printer mode directly after homing z in milling mode #9

Open drillabit opened 9 years ago

drillabit commented 9 years ago

Homing z in milling mode leaves lower z switch pressed. When switching to printer mode, any attempt to move z upwards fails because of the pressed switch. Homing will then drive the z axis to a crash with the lower z-switch fixture (the screw next to the switch) and fail. I did not dare to try out doing this the other way round (milling home after printer home), as the upper switch will likely get killed this way.

Cirrus01 commented 9 years ago

Agree, I had this after Object Output and then switching to milling mode. You should asign this to RF1000.

RF1000 commented 9 years ago

Hello,

we are going to improve the z-endstop checks in the next version of the firmware in order to avoid this trap.