jfarmer08
commented
2 years ago What type of hardware are you using? Have have tried setting this as it's own bridge?
Open socalcal opened 2 years ago
jfarmer08
commented
2 years ago What type of hardware are you using? Have have tried setting this as it's own bridge?
socalcal
commented
2 years ago I’m running on a Raspberry Pi Zero W, and I’m not sure how to set up wyze-smart-home as its own bridge.
On Aug 14, 2022, at 6:35 PM, jfarmer08 @.***> wrote:
What type of hardware are you using? Have have tried setting this as it's own bridge?
https://github.com/jfarmer08/homebridge-wyze-smart-home https://github.com/jfarmer08/homebridge-wyze-smart-home — Reply to this email directly, view it on GitHub https://github.com/RMCob/homebridge-wyze-connected-home-op/issues/37#issuecomment-1214517599, or unsubscribe https://github.com/notifications/unsubscribe-auth/AGMDXKYOBULSQ22FUQSWMPDVZGNFZANCNFSM55DLUCUQ. You are receiving this because you authored the thread.
dlewanda
commented
2 years ago I'm facing the same problem. I had tried this in the past but turned off 2FA for this exact reason. Per the email from Wyze dated 9/1/2022, they will be requiring 2FA very soon. I tried turning it on again tonight and am running into this problem. I'm also not sure what setting it up as it's own bridge would help. What is different about your fork @jfarmer08 of the original source as compared to this one?
So I have 2FA turned on, but the code is only good for 30 seconds at a time. I have not figured out how to enter the code in the config.json and restart homebridge fast enough for it to take the code. Any ideas? How have others been able to get this to work? Any and all help appreciated. Thanks!