Temperature not readable on TS80

[Lenni]

• I'm submitting a ...

  • [x] Bug report

• What is the current behavior?

On the TS80 the top half of the Temperature is cut off, if the Voltage is in the 2 digits.

• What is the expected behavior?

The Temperature should still be readable

• If the current behavior is a bug, please provide the steps to reproduce and if possible a minimal demo of the problem

Steps to reproduce:

1. Connect TS80 to Power source with more than 10V to provide
2. Start Heating up the Iron
3. Occasionally the Tempearture will be unreadbale when the voltage is over 10 V

• What is the motivation / use case for changing the behavior?

Better usability of the Firmware

• What are you running:

On the idle screen, you can hold the settings button and it will show you the firmware version.

• Model: TS80
• Firmware Version: 2.06
• PCB Version: 2
• Power Supply (Voltage and Current Rating) : QC 3.0 12V 1.5 A

[Ralim]

Thanks for narrowing it down to when 10V is displayed. Will look into the special case code now.

[Ralim]

Should be fixed. Give this a go:

TS80.zip