search

Rat-OS / RatOS-configuration

The RatOS modular klipper configuration
155 stars 136 forks source link

Prusa MK3S generated configuration errors #272

Open david-antos opened 4 months ago

david-antos commented 4 months ago

What happened

On RatOS 2.1, I have generated configuration for Prusa MK3S with Einsy board with the following parameters in the wizard: Screenshot_2024-06-14_21-34-49

It has following issues (I've repaired them step by step in the config manually in order to get complete list at once)

  1. Option 'points' in section 'quad_gantry_level' must be specified (quad_gantry_level entry in the config is quite pointless there, it can be corrected by removing the entry completely)

  2. tmc virtual endstop requires diag pin config corrected by adding

[tmc2130 stepper_x]
...
diag1_pin: !x_diag_pin
...

etc also for y, z, e (note the !, otherwise the toolhead crashes violently)

  1. MCU temperature not supported on atmega2560 (necessary to get rid of the [teperature_sensor Einsy] section)

  2. Pin 'display_rs_pin' is not a valid pin name on mcu 'mcu' (none of the display pins are defined for Einsy)

  3. Pin 'filament_switch_sensor_pin' is not a valid pin name on mcu 'mcu' (again, missing definition of pin names)

What did you expect to happen

The wizard should produce a valid and functional configuration

How to reproduce

As described above

Additional information

The pins are defined in the RatOS/boards/prusa-einsy/config.cfg, that file is not included in the config (I suppose that's the purpose of RatOS 2.1)

3dprintpt commented 2 months ago

Thanks David. I will try to reproduce this. No MK3S but I should be able to look at the files and check what is missing. Will see ;)