search

Reisyukaku / ReiNX

A modular Switch custom firmware
GNU General Public License v2.0
817 stars 85 forks source link

6.1.0 (possibly) breaks AutoRCM #79

Closed spoonh closed 5 years ago

spoonh commented 5 years ago

Updated to 6.1.0 while using AutoRCM, my switch does not boot into AutoRCM anymore and disabling/re-enabling auto rcm does not seem to do anything. No idea if i'm the only one with this occurrence.

Faerye0 commented 5 years ago

Same problem here

Reisyukaku commented 5 years ago

Updating the firmware at all ever will write a new firmware to the respective partitions, which overwrites the autorcm modification. That's always been a thing. So all you have to do is re-enable it.

noahc3 commented 5 years ago

OP said disabling/re-enabling doesn't work.

Reisyukaku commented 5 years ago

Because they're probably enabling and disabling again.. just do it once. All autorcm does is write to the RSA mod on the BCT in nand. It literally bricks your nand forcing the system into RCM mode. lol

spoonh commented 5 years ago

Because they're probably enabling and disabling again.. just do it once. All autorcm does is write to the RSA mod on the BCT in nand. It literally bricks your nand forcing the system into RCM mode. lol

This works, wasn't paying enough attention when i did this the first time i guess. Thanks for your help.

nnsee commented 5 years ago

Great stuff

spoonh commented 5 years ago

Having this issue again, switch is essentially in "bricked state" after disable/reenable but is recognized as Nintendo Switch rather than 'APX'. Any ideas?

Reisyukaku commented 5 years ago

uhh try fully powering it off (holding power for 20 seconds) and turn it on?

spoonh commented 5 years ago

uhh try fully powering it off (holding power for 20 seconds) and turn it on?

that works, but i have to do this every time i turn the console off now. eh, i'll just deal with it i guess.