search

Resumer3d / info

The firmware and documents(resume 3D printings from any printed layer automatically)
20 stars 5 forks source link

PA1 down #10

Open BlackienBad opened 5 years ago

BlackienBad commented 5 years ago

When I try to set the Baud rate I get this message: go to app boot to app PA1 down Baud rate:115200; Resumer3D:V1.1.3,compile date:Oct 30 2018 12:10:39 Resumer3D:V1.1.3,compile date:Oct 30 2018 12:10:39 en and nothing happens

hackaday3D commented 5 years ago

hello,it seems OK. after you set the baudrate the resumer3D will restart and display this information

BlackienBad commented 5 years ago

hello,it seems OK. after you set the baudrate the resumer3D will restart and display this information

I can't set the baudrate, this is the only message that I get, after this I tried to plug it in and when I pulled the charger nothing happened, I couldn't resume the print

hackaday3D commented 5 years ago

is there some messages while the printer connect to resumer3D via USB.

kiroke commented 5 years ago

I also have the same problem PA1 down so it doesn't work, even the firmware update has been tried but the result is the same, I sent an email for assistance I'm waiting for a reply .....

kiroke commented 5 years ago

my resumer after having configured it (badly) I try to connect it to the printer, at the end of the work it turns on red ok, but if I try to restart the print it turns blue and then turns red. Obviously it is caused by the message PA1 down, how to solve this problem I have to go back to the old UPS?

blueeagle69 commented 5 years ago

That's normal if the Resumer has saved gcode information. If you start another print it should go blue again. Or you can delete old info by holding down +- followed by OK. You're doing better than me. Since moving to an SKR 1.3 my Resumer will not connect it. And Eryone have been no help. Very disappointed considering I was a Kickstarter backer.