search

Resumer3d / info

The firmware and documents(resume 3D printings from any printed layer automatically)
20 stars 5 forks source link

Runout Sensor #12

Open blueeagle69 opened 5 years ago

blueeagle69 commented 5 years ago

Hi. I have been testing my filament runout sensor made with a microswitch. When the filament is inserted into the sensor the Resumer3D shows PA1 Down on BoxTool's output. Is this correct, or should it say PA1 down when there is no filament in the sensor? I just need to make sure I have my wiring to the microswitch correct.

Thanks!!

markniu commented 5 years ago

you are right, The PA1 pin is used for filament detect. it will output PA1 down when no filament.

blueeagle69 commented 5 years ago

Excellent, thank you. I will change the pin connections on my microswitch so the Resumer outputs PA1 down when the filament is removed from the sensor. Currently it outputs this when I insert filament!

Thanks for your help.

On Thu, 6 Jun 2019, 12:43 luojin012, notifications@github.com wrote:

you are right, The PA1 pin is used for filament detect. it will output PA1 down when no filament.

— You are receiving this because you authored the thread. Reply to this email directly, view it on GitHub https://github.com/Resumer3d/info/issues/12?email_source=notifications&email_token=ACMASZDX7R6ZNMS2BGOTV6TPZDZ5XA5CNFSM4HSULPCKYY3PNVWWK3TUL52HS4DFVREXG43VMVBW63LNMVXHJKTDN5WW2ZLOORPWSZGODXCSTHQ#issuecomment-499460510, or mute the thread https://github.com/notifications/unsubscribe-auth/ACMASZGPMYWC6OABISMCJGLPZDZ5XANCNFSM4HSULPCA .

blueeagle69 commented 5 years ago

Just an update. Now I have changed the cable position on my microswitch, I tested the Resumer3D. I pulled my short piece of filament I had inserted into my DIY sensor out, and shortly after the printer stopped and the nozzle moved away correctly :) Thanks for your help.