search

Resumer3d / info

The firmware and documents(resume 3D printings from any printed layer automatically)
20 stars 5 forks source link

OctoPrint #8

Open maxlinux2000 opened 5 years ago

maxlinux2000 commented 5 years ago

Hello, I use "octoprint" to print. On my laptop I have CURA, connected wia wifi to octorpint in an orange pi pc, which is connected by usb to the printer (a clone of prusa i3 with gt2560 card). I was thinking about putting the Resumer3D between the orange Pi and the printer, and putting an SD card in the printer.

In the manual I seem to understand that this can not be done. Is there any way to continue using the octoprint?

regards MaX

hackaday3D commented 5 years ago

hello,the latest resumer3D firmware support this case of putting resumer between octopi and printer. the resumer3D can pass through all the data between octopi and printer

cinealfa commented 4 years ago

maybe you can update the manual?