Front Sensor Bolts Stick out into Lid Groove

Ribbit-Network / ribbit-network-frog-hardware

The sensor for the world's largest crowdsourced network of open-source, low-cost, GHG Gas Detection Sensors.

https://www.ribbitnetwork.org/

MIT License

94 stars 26 forks source link

Front Sensor Bolts Stick out into Lid Groove #107

Closed keenanjohnson closed 2 years ago

keenanjohnson commented 2 years ago

When assembling a few Frog V2's I've noticed that the two Front sensor bolts stick out into the groove for the lid. This doesn't appear to cause any major issues, but is probably a good thing to clean up. I believe the bolt holes just need to be moved backward from the edge a bit.

keenanjohnson commented 2 years ago

Fixed in Version 15 of the Onshape Assembly.