RobertLorincz / Orbiter-Toolboards

Creative Commons Zero v1.0 Universal
35 stars 1 forks source link

Q maybe... findind default (must) shutdown_value: 0.0 is BAD! #13

Open ptegler opened 3 weeks ago

ptegler commented 3 weeks ago

Klipper issue?? seems flashing is an issue with anything other than _shutdownvalue: 0.0 set. this is NOT good...you should default to (hot end at a minimum) fans left on full power when the machine faults, to save clogs in the hot end from heat soak if the fan goes to zero when hot at fault.

RobertLorincz commented 3 weeks ago

I'm not sure what you mean here...Klipper does not flash any configuration values...The HW design is done in a way that during shutdown the hotend fan is automatically enabled without software request. Software request value in shutdown only works if the micro is still alive; if not, then it does not do anything...hence we have the HW implementation instead of software config.