search

RobertLorincz / Orbiter-Toolboards

Creative Commons Zero v1.0 Universal
35 stars 1 forks source link

Klipper not recognising so3 board #7

Closed Naclifford closed 2 months ago

Naclifford commented 2 months ago

I’ve connected the board up, I’ve connected to klipper via ssh and the board isn’t listed in the usb section or to get the board to be recognised dfu. So I can’t go any further to flash the board

RobertLorincz commented 2 months ago

I recommend going through the documentation and flash klipper if its not already flashed on the micro.

Naclifford commented 2 months ago

After reinstalling klipper still no joy, so far it’s an expensive paperweight, I’m at a loss…

RobertLorincz commented 2 months ago

hard to me to debug your issue, since I have no idea about your setup or how is the board connected. Some basic question, the toolboard power indicator LED is ON, correct? You have the USB cables and power cables connected as shown in the connection diagram? Did you try other USB ports as well?

Naclifford commented 2 months ago

Problem solved!!! Send board back to where I got it from for a replacement. The replacement works right out of the box..