search

Robo3D / User-Manuals

User Manuals for Robo printers - powered by Read the Docs
MIT License
1 stars 6 forks source link

Troubleshooting Guide for R1 Plus thermistor #118

Open spoogs2003 opened 6 years ago

spoogs2003 commented 6 years ago

Can we please have a troubleshooting guide for low temp error or no temp on the thermistor on the R1 plus. The guide should show how to check for connections issues on the hotend, thermistor long wire, and at the ramps board on the T0 pin.

mnacinopa commented 6 years ago

@spoogs2003 can you send a picture of the printer spitting out a low temp error?

spoogs2003 commented 6 years ago

Hi,

I don't have a picture handing. The only visual that will prompted to say the error would be on Mater control. A lot of the time we also determine the issue by listening to the customers description of how the printer is acting and then we come to that conclusion.

regards,

*Roberto Leal *B.A. History TECH SUPPORT

Phone: 858-213-5224

5070 Santa Fe St., Suite C San Diego, CA 92109

www.robo3d.com

New Robo C2 and R2 smart 3D printers available for pre-order! http://www.robo3d.com/robor2

This email transmission contains information that is intended to be confidential and privileged. If you receive this email and you are not a named addressee you are hereby notified that you are not authorized to read, print, retain, copy, or disseminate this communication without consent of the sender and that doing so is prohibited and may be unlawful. Please notify sender immediately by email if you have received this via email and delete and otherwise erase the email and any copies or attachments from your computer system. Also, email transmission cannot be guaranteed to be secure or error free as information could be intercepted, corrupted, lost, destroyed, arrive late or incomplete, or contain viruses. The sender therefore does not accept liability for any errors or omissions in the contents of the message, which arise as a result of email transmission.

On Thu, Nov 9, 2017 at 2:58 PM, mnacinopa notifications@github.com wrote:

@spoogs2003 https://github.com/spoogs2003 can you send a picture of the printer spitting out a low temp error?

— You are receiving this because you were mentioned. Reply to this email directly, view it on GitHub https://github.com/Robo3D/support.robo3d.com/issues/118#issuecomment-343319718, or mute the thread https://github.com/notifications/unsubscribe-auth/AaDUouWgMFSID08XFFB1Mbbt1QCFiVG8ks5s04OqgaJpZM4QXArH .