VirtualBox install manual does not state the login password

[BenjaminKobjolke]

I followed the install guide but what is the password for debian login fhuser ?

[prabhasp]

The password is listed in this section of the guide: https://github.com/SEL-Columbia/formhub/wiki/How-To-Run-Your-Own-Formhub-Virtual-Machines-on-VirtualBox#configure-outgoing-email

On Sunday, November 2, 2014, Benjamin Kobjolke notifications@github.com wrote:

I followed the install guide https://github.com/SEL-Columbia/formhub/wiki/How-To-Run-Your-Own-Formhub-Virtual-Machines-on-VirtualBox but what is the password for debian login fhuser ?

Reply to this email directly or view it on GitHub https://github.com/SEL-Columbia/formhub/issues/1349.

Prabhas Pokharel http://prabhasp.com twitter/skype/facebook/whatever: prabhasp

[BenjaminKobjolke]

Thanks! The problem is that it is needed earlier in the guide already. Because after installation it says "To avoid problems with monogodb not starting correctly on boot, always shut down the VM as user root using the shutdown command like this:"

So I didn't read any further because I thought it should have been mentioned by then.

[camoncal]

I can't find where is the password for fhuser. I already tried typing fhuser as user and password, but it says that the credentials are invalid. Can somebody help me with this inquire. Thank you!

I downloaded the VDI, to run it using VM.

[vr2262]

As @prabhasp mentioned, the password is given in this section:

https://github.com/SEL-Columbia/formhub/wiki/How-To-Run-Your-Own-Formhub-Virtual-Machines-on-VirtualBox#configure-outgoing-email

Once the VM has booted, login at the prompt as either user root, or fhuser and then use sudo to become root.

The password for both accounts is set to all4one but you should change those using the passwd command, later.

[camoncal]

Thank you so much!, I am sorry I haven´t seen it.