search

STMicroelectronics / STM32CubeF7

STM32Cube MCU Full Package for the STM32F7 series - (HAL + LL Drivers, CMSIS Core, CMSIS Device, MW libraries plus a set of Projects running on all boards provided by ST (Nucleo, Evaluation and Discovery Kits))
Other
322 stars 191 forks source link

ADC2, ADC3 no continuous conversion mode possible in STM32CubeMX when ADC1 enabled #63

Closed rudi219 closed 2 years ago

rudi219 commented 2 years ago

Describe the set-up

Describe the bug It is not possible to enable continuous conversion mode for ADC2 or ADC3 when ADC1 is enabled. It worked with Firmware V1.16.0 and before and is independent of the STM32CubeMX version (tested with V6.2, 6.3, 6.4)

How To Reproduce

  1. Create a new project in STM32CubeMX for STM32F765Z
  2. Enable ADC1 by enabling one channel
  3. Enable ADC2 by enabling one channel
  4. Enabling continuous conversion mode for ADC2 is not possible (same for ADC3)
ASELSTM commented 2 years ago

Hi @rudi219,

Thank you for this report. The point you reported is actually related to the CubeMX generation problem and not to the firmware published in this repository. Unfortunately, we don't treat aspect related to CubeMX tool in our GitHub repositories. They are rather treated at the STM32CubeMX dedicated page of the ST Community .

Since this issue is not directly related to the STM32Cube firmware but rather to our ecosystem, please allow me then to close this thread. Thank you for your comprehension.

With regards,

rudi219 commented 2 years ago

Hello,are you sure, that it is not related to the firmware? It works with firmware up to 16.0 and different CubeMX versions, but not newer firmware versions.Best regards,RudiAm 22.02.22, 10:22 schrieb ASELSTM @.***>:

Hi @rudi219, Thank you for this report. The point you reported is actually related to the CubeMX generation problem and not to the firmware published in this repository. Unfortunately, we don't treat aspect related to CubeMX tool in our GitHub repositories. They are rather treated at the STM32CubeMX dedicated page of the ST Community . Since this issue is not directly related to the STM32Cube firmware but rather to our ecosystem, please allow me then to close this thread. Thank you for your comprehension. With regards, —Reply to this email directly, view it on GitHub, or unsubscribe.Triage notifications on the go with GitHub Mobile for iOS or Android. You are receiving this because you were mentioned.Message ID: @.***>