When I switch on，how long does it take to warm up? Does it show it's ready like the Nano?
When to use cold start? How to use it best?
For survey mode
When Zen is INSIDE the case
I notice it is only about half the CPM displayed.
So you have preset Zen to cut out some CPM for survey mode?
How do you determine how much CPM to cut?
I want to amend because I notice it displays CP5s ...ie. counts per 5 seconds instead of CPM as in drive mode
Still in survey mode,
Now I take zen OUTSIDE the case and put on the source I want to monitor.
The CPM I get is just the radiation emitted from the source. Correct?
You have programmed the ZEN to subtract out the ambient CPM??
For Settings...configure your device
We should not touch this. Correct?
When do we need to use it?
For debug info
What modules and data do I need to connect?
How long does the battery last after a full charging
At the bottom of the screen
Please explain the symbols
Info 79%
GM
GPS0
SD
WF
BT
When I switch on，how long does it take to warm up? Does it show it's ready like the Nano?
When to use cold start? How to use it best?
For survey mode When Zen is INSIDE the case I notice it is only about half the CPM displayed. So you have preset Zen to cut out some CPM for survey mode? How do you determine how much CPM to cut? I want to amend because I notice it displays CP5s ...ie. counts per 5 seconds instead of CPM as in drive mode
Still in survey mode, Now I take zen OUTSIDE the case and put on the source I want to monitor. The CPM I get is just the radiation emitted from the source. Correct? You have programmed the ZEN to subtract out the ambient CPM??
For Settings...configure your device We should not touch this. Correct? When do we need to use it?
For debug info What modules and data do I need to connect?
How long does the battery last after a full charging
At the bottom of the screen Please explain the symbols Info 79% GM GPS0 SD WF BT