search

Saka1984 / ubidisplays

Automatically exported from code.google.com/p/ubidisplays
0 stars 0 forks source link

Screen Extending ? #11

Open GoogleCodeExporter opened 8 years ago

GoogleCodeExporter commented 8 years ago 
Do i require screen extendning for the application to work 

I can see only a single screen on the application even after connecting the 
projector ?

Original issue reported on code.google.com by harssh.s...@gmail.com on 19 Mar 2013 at 12:23

GoogleCodeExporter commented 8 years ago 
In normal use, yes - you need screen extending.  One screen being the projector 
and the normal monitor being used for configuration.

However, technically, no.  You can calibrate and configure the system all on 
one screen.  This process is a bit akward though! :)

May I ask what you are trying to do?

Original comment by asheepca...@gmail.com on 19 Mar 2013 at 5:48

GoogleCodeExporter commented 8 years ago 
[deleted comment]
GoogleCodeExporter commented 8 years ago

Original comment by asheepca...@gmail.com on 19 Mar 2013 at 5:52

GoogleCodeExporter commented 8 years ago 
Hi
Thanks for replying 

All I am trying to do is implement your software 
But I can't seem to get it working 

After I draw the surface 

I can't seem to be getting envelope type logo nor red lines 

I am using my laptop and projector for it 
And I can only one screen when I start your software

Original comment by harssh.s...@gmail.com on 19 Mar 2013 at 5:59

GoogleCodeExporter commented 8 years ago 
The envelope only happens when you are projecting.  Try the "turn white" button 
to check which screen you are affecting.

You need to make sure you set up your projector as an extended display in the 
screen resolution dialogue.  That should enable it to detect both monitors 
attached to the computer.

You may also find that running it on a laptop can be a bit slow.  I recommend a 
processor comparable to an i5 or later for best results.

Original comment by asheepca...@gmail.com on 20 Mar 2013 at 11:09