search

Sakati84 / 3DPrintColorizer

Software & Hardware to do multi color printing with Sharpies
GNU General Public License v3.0
425 stars 56 forks source link

Missing certain settings that should be enabled by default in the cura profile in software folder #121

Open doggohusk opened 12 months ago

doggohusk commented 12 months ago

was going thru recommeded settings in wiki because i got terrible layer adhesion i could open my print up with barely putting any preassure and saw that the (im just gonna list settings here) Retract at Layer Change was off, Relative Extrusion was also off, Wall line count was set to 1, Top/Bottom speed Outer wall speed was set to 30 which is above recommeded 10-15 range, Extra infill wall count was at 0, Retract before outer wall was off, i think these should be on by default in the included cura profile orrrr im just dumb and didnt import the profile in correctly if thats the case you can just close this issue

thisnyjared commented 7 months ago

Yeah I just changed them back to default and it worked fine.