search

Sakati84 / 3DPrintColorizer

Software & Hardware to do multi color printing with Sharpies
GNU General Public License v3.0
434 stars 56 forks source link

Suggestion: have script skip painting over the infill #69

Open christopherjamesmeyers opened 3 years ago

christopherjamesmeyers commented 3 years ago

I've noticed the script spends a lot of time painting over infill that wouldn't normally be seen and causes issues with layer adhesion (perhaps not letting the ink dry)

Sakati84 commented 3 years ago

Normally it should only paint the walls. Can you send me a photo of the infill painting?

christopherjamesmeyers commented 3 years ago

Realized I was only looking at the first few layers before it started the infill. however, there is still the issue of layer adhesion

csanii123 commented 3 years ago

I didn't have any issues with my basic multi-color prints and layer adhesion. Do you have any issues when doing non-multi-color prints ? Perhaps you don't have your bed close enough and thus not enough "squish" between layers.

Sakati84 commented 3 years ago

What is your top/bottom speed?

christopherjamesmeyers commented 3 years ago

@csanii123 regular prints work just fine @Sakati84 15 mm/s, but i have tried halving it as ive seen suggested with no success, as well as halving the Vmax Z from the 25 suggested in the setup